Baxter Colleague CX Infusion Pump




Get A Quote

Save up to 80% on pre-owned Baxter Colleague CX infusion pumps.
Request a Quote for this product now.

Product Specifications

Ac power Requirements:

100-120 VAC, 60Hz

Leakage Current:

Less than 300 u amps earth leakage (tested per UL 2601)

External Fuses:

1.6 amp Type T (time delay) 250V

Power Cord:

2.9 m (9 feet) long with integrally molded hospital grade plug

Battery Supply System:

5 hours operating time at 100 mL/hr (fully charged new batteries) 8 hours to recharge to 80% of capacity. Internal charge system recharges batteries whenever the device is connected to an AC outlet

Range of Programmable Flow Rates:

Primary Infusion: 0.1 to 99.9 mL/hr in 0.1 mL/hr increments
1 to 1200 mL/hr in 1 mL/hr increments
Piggyback Infusion: 0.1. to 99.9 mL/hr in 0.1 mL/hr increments
1 to 500 mL/hr in 1 mL/hr increments
Note: Rate limits can be configured for values less Than those stated above.

Volume to be Infused:

0.1 – 99.9 mL in 0.1 mL increments 1- 9999 mL mL/hr in 1 mL increments
Note: Volume to be Infused limits can be configured for values less than those stated above

KVO:

0.1 – 5 mL/hr in 0.1 mL increments (configurable option) or programmed rate whichever is less.

Priming rate:

500 mL/hr (to be used only when not connected to patient)

Advance Air Rate to Advanced an Air Bubbles:

At the same rate programmed for the current primary or piggyback infusion.

Air Bubble Setting:

Measured accumulations of approximately
25 microliters
50 microliters
100 microliters 150 microliters
The Air Bubble Setting is a configurable option.

Auto Restart:

Allows the pump channel to automatically restart if an occlusion is relieved within one minute after detection. This configuration option allows 0 to 9 restarts before manual intervention is required.

Nominal Downstream:

Alarm sensitivity is a configurable option. Rate range in mL/hr

<21
2 psig (Minimum)
5 psig (Moderate)
9 psig (Maximum)

21- 200
4 psig (Minimum)
8 psig (Moderate)
12 psig (Maximum)

>200
6 psig (Minimum)
11 psig (Moderate)
15 psig (Maximum)

Device Size:

Approximately 10″ H x 7.75″ W x 7.75″ D
(254 x 197 x 197 mm)
Not including clamp knob or power cord

Device weight:

Approximately 10.4 lbs (4.7kg)

Environmental Operating Limits:

59º F – 100º F (15º C – 38º C)

Environmental Storage and Transport Limits:

-20º F – 135º F (-29ºC – 57º C), 10-100% Reliable Humidity including condensation, 500-1060 hPa Barometric Pressure

Ground Impedance:

Less than 0.2 ohms (tested per UL-2601)

Solution Container Height:

Pump will operate at all programmable flow rates with a solution container height ranging from -36 to +48 inches. Container height is measured from the pump channel selected for use.

Interfaces:

Attachment to a remote nurse call system A variety of systems exist which enable alert and alarm conditions to be transmitted to a remote location via the communications port on the rear panel assembly of the pump. See the service manual for additional information.

Features:

Preset Label Library
User Defined Label Library
Dose Calculator
View Limits Soft Key
Programmable Personalities

For service, parts, PM or rental see our Services section