Ac power Requirements:
100-120 VAC, 60Hz
Less than 300 u amps earth leakage (tested per UL 2601)
1.6 amp Type T (time delay) 250V
2.9 m (9 feet) long with integrally molded hospital grade plug
Battery Supply System:
5 hours operating time at 100 mL/hr (fully charged new batteries) 8 hours to recharge to 80% of capacity. Internal charge system recharges batteries whenever the device is connected to an AC outlet
Range of Programmable Flow Rates:
Primary Infusion: 0.1 to 99.9 mL/hr in 0.1 mL/hr increments
1 to 1200 mL/hr in 1 mL/hr increments
Piggyback Infusion: 0.1. to 99.9 mL/hr in 0.1 mL/hr increments
1 to 500 mL/hr in 1 mL/hr increments
Note: Rate limits can be configured for values less Than those stated above.
Volume to be Infused:
0.1 - 99.9 mL in 0.1 mL increments 1- 9999 mL mL/hr in 1 mL increments
Note: Volume to be Infused limits can be configured for values less than those stated above
0.1 - 5 mL/hr in 0.1 mL increments (configurable option) or programmed rate whichever is less.
500 mL/hr (to be used only when not connected to patient)
Advance Air Rate to Advanced an Air Bubbles:
At the same rate programmed for the current primary or piggyback infusion.
Air Bubble Setting:
Measured accumulations of approximately
100 microliters 150 microliters
The Air Bubble Setting is a configurable option.
Allows the pump channel to automatically restart if an occlusion is relieved within one minute after detection. This configuration option allows 0 to 9 restarts before manual intervention is required.
Alarm sensitivity is a configurable option. Rate range in mL/hr
2 psig (Minimum)
5 psig (Moderate)
9 psig (Maximum)
4 psig (Minimum)
8 psig (Moderate)
12 psig (Maximum)
6 psig (Minimum)
11 psig (Moderate)
15 psig (Maximum)
Approximately 10" H x 7.75" W x 7.75" D
(254 x 197 x 197 mm)
Not including clamp knob or power cord
Approximately 10.4 lbs (4.7kg)
Environmental Operating Limits:
59º F - 100º F (15º C - 38º C)
Environmental Storage and Transport Limits:
-20º F - 135º F (-29ºC - 57º C), 10-100% Reliable Humidity including condensation, 500-1060 hPa Barometric Pressure
Less than 0.2 ohms (tested per UL-2601)
Solution Container Height:
Pump will operate at all programmable flow rates with a solution container height ranging from -36 to +48 inches. Container height is measured from the pump channel selected for use.
Attachment to a remote nurse call system A variety of systems exist which enable alert and alarm conditions to be transmitted to a remote location via the communications port on the rear panel assembly of the pump. See the service manual for additional information.
Preset Label Library
User Defined Label Library
View Limits Soft Key